Instantly download HP0-Y51 training test engine

Refer to the exhibit.

The switches shown in the exhibit use the HP VAN SDN Controller as the OpenFlow controller. They connect to the controller on their out-of-band management (OOBM) ports, but these connections are not shown in the exhibit. The switches also run spanning tree protocol. An SDN application installed on the HP VAN SDN Controller is programmed to discover live ports, find redundant paths, and create loopfree paths for traffic infrastructure shown in the exhibit. However the application is not able to complete these functions because the switches are reporting some ports as blocked.
What should the administrator do to let the application create the loopfree paths?

• A. Disable spanning tree on the OpenFlow-enabled switches and do not configure link aggregation.
• B. Disable spanning tree on the OpenFlow-enabled switches and configure the redundant links as static link aggregations
• C. Enable spanning tree on the OpenFlow-enabled switches and configure all of the redundant links as egress-only-ports
• D. Enable spanning tree on the OpenFlow-enabled switches but set the application as the spanning tree flood parameter controller.

A company has an HP BYOD solution to let guests connect to a Guest SSID and log in through a registration page. The company needs an Employee SSID which enforces Wi-Fi Protected Access 2 (WPA2) with 802.1X. Employees must authenticate with certificates. Before authenticating with a device for the first time, the employees should be able to connect to the Guest SSID, access the guest registration page, and download valid certificates.
How does the administrator configure User Access Manager (UAM) to allow employees to download certificates from the registration page?

• A. In the Guest Manager settings for the employee manager, enable auto-registration in certificate mode.
• B. The User Endpoint Settings, create an Endpoint Configuration Distribution Policy that permits the employee groups.
• C. In the Guest access policy, make sure that a policy binds the Employee SSID to an access rule with the onboarding VLAN ID.
• D. In the Employee access service, make sure that a policy binds the Employee SSID to an access rule with the onboarding VLAN I

Refer to the exhibit. (Note: the IDs in the exhibit have been truncated to simplify references to them) An administrator creates user "monitor", who should have read only access to the HP VLAN SDN Controller. The administrator needs to enter this command to finish up the user account.

keystone user-add-role - -user-ID ID1 - - tenant-id ID2 - -role-ID ID3
What are the correct values for ID1, ID2, and ID3?

• A. ID1 = 9b; ID2 = a6; ID3=d0
• B. ID1 = a6; ID2 = 0c; ID3=94
• C. ID1 = 94; ID2 = a6; ID3=0c
• D. ID1 = a6; ID2 = 0c; ID3=d0

Table of Acronyms

Refer to the exhibit.

An administrator is planning an MPLS and VPLS Martini to connect customer sites 1, 2, and 3. How many pseudo must the administrator define?

• A. Six-twoeach on PE-1, PE-2, and PE-3
• B. Three-one each on PE-1, PE-2, and PE-3
• C. Four-two on PE-1, one on PE-2 m and one on PE-3
• D. Two-two on PE-1, with one connected to PE-2 and PE-3

A company has an HP Unified Wired-Wireless controller that controls HP MultiService Mobility (MSM) APs. The network administrator wants to implement protection against rogue APs in the company's campus environment. Only APs that have approved MAC addresses should be allowed to operate and support clients. Controlled APs should send disassociation frames to prevent clients from connecting to rogue APs.
The administrator sets up APs to monitor the area and creates a permitted MAC address list with the approved AP MAC addresses. The administrator has not configured any other Intrusion Detection System (IDS) settings. Which additional step must the administrator complete?

• A. Deploy the permitted MAC address list as a static attack list to each controlled AP
• B. Configure the permitted vendor and permitted SSID lists.
• C. Enable countermeasures.
• D. Enable a dynamic blacklist.