Instantly download NSE8_811 training test engine

Anti-Virus Real-Time Protection is enabled without any exclusions.
Referring to the exhibit, which two behaviors will the FortiClient endpoint have after receiving the profile update from the FortiClient EMS? (Choose two.)

• A. If the Real-Time Protection does not detect a virus, the user will be able to access a downloaded file when the FortiSandbox is unreachable.
• B. Access to a downloaded file will always be allowed after 60 seconds when the FortiSandbox is reachable.
• C. Files executed from a mapped network drive will not be inspected by the FortiClient endpoint AntiVirus
  engine.
• D. The user will not be able to access a downloaded file for a maximum of 60 seconds if it is not a virus and the FortiSandbox is reachable.

A FortOS devices is used for termination of VPNs for number of remote spoke VPN units (designated group A spokes) using a phase 1 main mode dial-up tunnel using pre-shared. Your company recently acquired another organization. You are asked establish VPN correctively for the newly acquired organization's sites which new devices will be provisioned (designated Group B spokes). Both exiting (Group A) and new (Group B) spoke units are dynamically addressed. You are asked to ensure that spokes from the acquired organization (Group B) have different access permission than your existing VPN spokes (Group A).
Which two solutions meet the represents for the new spoke group? (Choose two.)

• A. Implement a new phase 1 dial-up main mode tunnel with a different pre-shared key than the Group A
  spokes.
• B. Implement a new phase 1 dial-up main mode tunnel with pre-shared keys and XAuth.
• C. Implement a new phase 1 dial-up main mode tunnel with certificate authentication.
• D. Implement separate phase 1 dial-up aggressive mode tunnels with a distinct peer ID.

FortiMail configured with the protected domain "internal lab".
Which two envelopes addresses will need an access control rule to relay e-mail sent for unauthenticated users? (Choose two.)

• A. MAIL FROM: trainmg@internallab; RCPT TO student@mternallab
• B. MAIL FROM: traming@fortinet com: RCPT TO: student@fortinet com
• C. MAIL FROM student@internal lab: RCPT TO [email protected]
• D. MAIL FROM student@fortinet com: RCPT TO [email protected]

Exhibit
Click the Exhibit button.
You are trying to configure Link-Aggregation Group (LAG), but ports A and B do not appear on the list of member options. Referring to the exhibit, which statement is correct in this situation?

• A. The FortiGate SFP+ slot does not have the correct module.
• B. The FortiGate model does not have an Integrated Switch Fabric (ISF).
• C. The FortiGate interfaces are defective and require replacement.
• D. The FortiGate model being used does not support LAG.

You are asked to implement a single FortiGate 5000 chassis using Session-aware Load Balance Cluster (SLBC) with Active - Passive FortinControllers. Both FortiControllers have the configuration shown below, with the rest of the configuration set to the default values:
config system ha
set mode dual
set password fortinetnse8
set group-id 5
set chassis-id 1
set minimize-chassis-failover enable
set hbdev "b1"
end
Both FortiControllers show Master status. What is the problem in this scenario?

• A. The priority should be set higher for ForControllers on slot-1.
• B. The chassis ID settings on FotiControllers on slot 2 should be set to 2.
• C. The management interface of both FotiControllers was connected on the some network.
• D. The b1 interface the two FortiConrollers do not see each other.