[Jan 03, 2022] Get to the Top with 300-815 Practice Exam Questions
Use Real 300-815 Dumps Free Sample Questions and Practice Test Engine
What is the duration, language, and format of Cisco 300-815: Implementing Cisco Advanced Call Control and Mobility Services Exam
- Exam duration: 90 minutes
- Format: Multiple selection
- Applicability: 3 years
- Exam language: English
Introduction to Cisco 300-815: Implementing Cisco Advanced Call Control and Mobility Services Exam
Implementing Cisco Advanced Call Control and Mobility Services v1.0 CLACCM 300-815 is a 90-minute exam associated with the CCNP Collaboration Certification. This exam tests a candidate’s knowledge of advanced call control and mobility services, including signaling and media protocols, CME/SRST gateway technologies, Cisco Unified Board Element, call control and dial planning, Cisco Unified CM Call Control, and mobility. The course, Implementing Cisco Advanced Call Control and Mobility Services, helps candidates to prepare for this exam. In addition, you use the Dynamic Host Configuration Protocol (DHCP) to fix faults, network security, and VLAN settings, as well as many other common network concerns. The chance to acquire new concepts and to improve understanding via a range of integrated lab settings is an essential element of this course. You may resolve your problems by using 300-815 dumps and different laboratory conditions in a wide range of case studies.
NEW QUESTION 10
An engineer is configuring a call park feature in Cisco Unified Communications Manager Express. Which command does the engineer use to ensure that the call is reverted to the user after 60 seconds?
- A. R2(config-ephone-dn)#park-slot timeout 60 limit 2 recall alternate 3002
- B. R2(config-ephone-dn)#park-slot timeout 30 limit 2 recall alternate 3002
- C. R2(config-ephone-dn)#park reservation-group 60
- D. R2(config-ephone-dn)#park reservation-group 1
Answer: A
NEW QUESTION 11
Which section under the Real-Time Monitoring Tool allows for reviewing the call flow and signaling for a SIP call in real time?
- A. Voice/Video > Session Trace Log View > Open From Local Disk
- B. Voice/Video > Session Trace Log View > Real Time Data
- C. System > Tools > Trace and Log Central
- D. Analysis Manager > Inventory > Trace File Repositories
Answer: B
Explanation:
Reference:
https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications- manager-callmanager/213583-procedure-to-analyse-call-flow-of-sip-ca.html
NEW QUESTION 12
Configure Call Queuing in Cisco Unified Communications Manager. Where do you set the maximum number of callers in the queue?
- A. in the queuing configuration
- B. in the telephony service configuration
- C. in Cisco Unified CM Service Parameters
- D. in Cisco Unified CM Enterprise Parameters
Answer: A
NEW QUESTION 13
When configuring hunt groups, where do you add the individual directory numbers that will be part of the group?
- A. route group
- B. hunt pilot
- C. line group
- D. hunt list
Answer: C
NEW QUESTION 14
An engineer is troubleshooting local ringback on a Cisco SIP gateway The gateway is not ignoring the SIP 180 response with SDP from the service provider, and the far end device is sending the 180 with SDP to play ringback from the IP address specified m the SDP Which configuration change must be made on the gateway to resolve the issue?
- A. Router(config-sip-ua)# no disable-early-media 180
- B. Router(con(-voi-serv)# no disable-early-media 180
- C. Router(conf-voi-serv)# dlisable-early-media 180
- D. Router(conftg-sip-ua)# disable-early-media 180
Answer: D
NEW QUESTION 15
Refer to the exhibits.
Regions have been configured for all major branches based on the available circuit bandwidth. Some calls from Region A endpoints to Region B endpoints are failing to connect. How is this issue resolved?
- A. Add a media resource to transcode between available capabilities.
- B. Increase the number of available media termination points.
- C. Update the calling search space for affected endpoints to none.
- D. Update all regions to 8 kbps maximum audio bitrate.
Answer: A
NEW QUESTION 16
Which configuration element of a hunt group allows for changing Calling Party Transformations settings?
- A. route group
- B. hunt pilot
- C. line group
- D. hunt list
Answer: B
NEW QUESTION 17
Refer to the exhibit.
A user reports that when they call a specific phone number, no one answers the call, but when they call from a mobile phone, the call is answered. The engineer troubleshooting the issue is expecting the far-end gateway to cut through audio on the 183 Session Progress SIP message. Which SIP Profile configuration element is necessary for the Cisco Unified Communications Manager to send acknowledgement of provisional responses?
- A. Allow Passthrough of Configured Line Device Caller Information must be enabled.
- B. Early Offer for G Clear Calls must be enabled.
- C. Accept Audio Codec Preferences in Received Offer must be set to On.
- D. On the SIP Profile, the configuration parameter SIP Rel1XX Options must be set to Send PRACK for all 1xx Messages.
Answer: D
NEW QUESTION 18
An IP Telephony administrator is deploying IP phones The administrator has an existing Cisco UCME router with several SCCP & SIP phones registered. The administrator receives a request for a new SIP phone with MAC address 1111 2222.3333 and directory number 2050 to be added in the Cisco UCME. Which two configurations should be added in CME to support this request? (Choose two )
- A. Option D
- B. Option B
- C. Option A
- D. Option E
- E. Option C
Answer: A,E
NEW QUESTION 19
Which action is correct with respect to toll fraud prevention configuration in the Cisco Unified Communications Manager Express?
- A. Configure the command no ip address trusted authenticate under "voice service voip".
- B. Enable Secondary Dial tone on Analog and Digital FXO Ports.
- C. Configure IP Address Trusted Authentication for Incoming VoIP Calls.
- D. Configure Direct Inward Dial for Incoming ISDN Calls with overlap dialing.
Answer: C
NEW QUESTION 20
An engineer must configure a secure SIP trunk with a remote provider, with a specific requirement to use port
5065 for inbound and otubound traffic. Which two items must be configured to complete this configuration?
(Choose two.)
- A. Destination Port in SIP Trunk Security Profile configuration
- B. Destination Port in SIP Information section of the SIP Trunk configuration
- C. Incoming Port in SIP Trunk Security Profile configuration
- D. Incoming Port in Security Information of the SIP Profile configuration.
- E. Incoming Port in SIP Information section of the SIP Trunk configuration.
Answer: B,C
NEW QUESTION 21
The administrator of ABC company is troubleshooting a one-way audio issue for a call that uses
H.323protocol (slow-start mode). The administrator requests that you provide the IP and port information of the Real- Time Transport Protocol traffic that had the one-way audio call.
You gather the H.225 and H.245 messages for one of the one-way audio calls. Where can you find the RTP IP and port information for both sides? (Note: This call flow has not invoked any media resources like MTP or transcoders).
- A. H.245 Open Logical Channel
- B. H.245 Terminal Capability Set
- C. H.245 Open Logical Channel Ack
- D. H.225 Connect
Answer: A
NEW QUESTION 22
Due to a shortage of physical interfaces on a device the administrator requires that a loopback for RTP is used. Which command is required when using a loopback interface for RTP?
- A. voice-class sip early-offer forced.
- B. voice-class sip bind media source-interface Loopback0
- C. voice-class sip bind control source-interface Loopback0
- D. voice-class sip resources priority mode passthrough
Answer: B
NEW QUESTION 23
An engineer must implement call restriction to toll-free numbers using a class of restriction in a branch Cisco UCME. In which two places is the corlist incoming or cor Incoming command configured? (Choose two.)
- A. "dial-peer cor custom" configuration mode
- B. "telephony-service" configuration mode
- C. "voice register pool" configuration mode
- D. "voice register global" configuration mode
- E. "ephone-dn' configuration mode
Answer: C,E
NEW QUESTION 24
What is a component of Cisco Unified Mobility?
- A. Mobile Connect
- B. Smart Client Support
- C. Unified IVR
- D. Single Number Connect
Answer: A
NEW QUESTION 25
......
Official Courses for Cisco 300-815 Exam Preparation
Before taking the exam, you have to master all the above topics. The most rational way to do this is by adopting corresponding Cisco training. These are three programs you can apply for:
- Implementing and Understanding Cisco Advanced Call Control and Mobility Services (CLACCM)
During this official course, you will get solid knowledge about how to utilize CU-CM features to simplify the communications system into a modular, lightweight, and reliable collaboration approach. You will also learn about several other features, such as Globalized Call Routing, Cisco Extension Mobility, Cisco Unified Mobility, and many others. Using this course as your guide will bolster your studies for the test. The training is offered in three forms: 5 days of instructor-led classes, 5 days of virtual sessions, or a set of E-learning tools and materials equivalent to 5-day preparation.
- Implementing and Operating Cisco Collaboration Core Technologies (CLCOR)
If you start from the very beginning, it’s better to first enroll in training for the core test. It lets you prepare for the Cisco CCNP Collaboration from scratch, covering the most basic concepts. During it, you'll prepare for advanced-level positions based on Cisco collaboration technologies deployment and service. You will also acquire the expertise and skills one needs to have to install and deploy common collaboration and networking technologies. Also, it is focused on the areas like configuration, call management, service quality, and other Cisco collaboration applications. It can be followed as 8-day sessions guided by an instructor, 8-day virtual training, or E-learning.
- Understanding Cisco Collaboration Foundations (CLFNDU)
This is one more training course that would make you ready for this test. It provides you with all the information you need to know to maintain a simple Cisco Unified Communications Manager and handle the Session Initiation Protocol (SIP) gateway. It encompasses preliminary settings, the management of systems, customer management, media services management, as well as tools used for troubleshooting and maintenance of CU Communications solutions. This program also has a duration of 5 days regardless of its format, which includes the options such as instructor-led, virtual classroom, and E-learning.
Pass Cisco 300-815 exam - questions - convert Tets Engine to PDF: https://www.pass4training.com/300-815-pass-exam-training.html
2022 Realistic Verified Free Cisco 300-815 Exam Questions : https://drive.google.com/open?id=1trm868udhAk6d9QUVlZWtmsU9_Bi1YrO
