[Mar-2022] Updated DCS-IE DES-1121 Exam Questions BUNDLE PACK
Master The EMC Content DES-1121 EXAM DUMPS WITH GUARANTEED SUCCESS!
NEW QUESTION 32
You have just presented storage to an ESXi server and want to rescan the storage adapter to ensure the server can see the new volume Based on recommended best practices, what is the preferred method to perform this task?
- A. Use the vSphere Client to perform the rescan of the host
- B. Use the vSphere VSI plugin to rescan the entire cluster
- C. Run the command from a non-cluster host using the ESX CLI
- D. Run the command from the ESXi server with the ESX CLI enabled
Answer: B
NEW QUESTION 33
Which Solutions Enabler daemon is responsible for Oatekeeper management?
- A. storgnsd
- B. storsrvd
- C. storslpd
- D. storapid
Answer: C
NEW QUESTION 34
What does a service level define*?
- A. Expected average response time target for a Storage Group
- B. Expected average throughput for a Storage Group
- C. Expected average throughput for a disk group
- D. Expected average response time target for a disk group
Answer: A
NEW QUESTION 35
From an application perspective what should be done prior to performing an SRDF Fallback operation?
- A. Continue accessing the R2 devices
Run the command and then start accessing the R1 devices - B. Stop accessing the R2 devices
Start accessing the R1 devices before running the command - C. Continue accessing the R2 devices
Start accessing the R1 devices before running the command - D. Stop accessing the R2 devices
Run the command and then start accessing the R1 devices
Answer: D
NEW QUESTION 36
A PowerMax administrator is provisioning their environment using Solutions Enabler 9.0 and Unisphere for PowerMax Two large Storage Resource Pools (SRPs) have been configured for virtual provisioning. The pools are setup with RAID 5 (7+1) TDATs and there are no errors The administrator is able to fully access and browse each pool's elements and decided to make some modifications to the pools However, they are unable to edit or make any changes to the pool attributes What is the most likely reason for this issue?
- A. Pool modification is restricted to only Dell Technologies personnel
- B. An unsupported version of Unisphere for PowerMax was used
- C. One of the SRPs is not configured as the default SRP
- D. An unsupported version of Solutions Enabler was used
Answer: A
NEW QUESTION 37
What is the maximum number of supported cascaded Storage Group levels in PowerMax and VMAX Family arrays?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION 38
In Unisphere which role has limited privileges that can only view the information about a storage array and is unable to make any configuration changes?
- A. None
- B. Auditor
- C. Monitor
- D. StorageAdmin
Answer: C
NEW QUESTION 39
What is a minimum requirement for Dell EMC VSI 8.0 on a VMAX All Flash array?
- A. Unisphere 9.x
- B. 5977.1131.1131
- C. Unisphere 8.x
- D. 5977 1125.1125
Answer: D
NEW QUESTION 40
Which Open Replicator device type resides on the array running Open Replicator?
- A. Remote
- B. Donor
- C. Control
- D. Local
Answer: C
NEW QUESTION 41
Two PowerMax arrays have been configured for replication using SRDF During a disaster recovery operation production has been transferred to the R2 devices at the target site. Which operation begins the transfer of accumulated invalid tracks from the R2s to the R1s while production work continues on the R2s?
- A. Fallback
- B. Update
- C. Failover
- D. Resume
Answer: D
NEW QUESTION 42
In PowerMax VMAX All Flash and VMAX3 which thin provisioning component can be changed with SYMCLI or Unisphere?
- A. Storage Group
- B. Virtual Provisioning Pool
- C. Storage Resource Pool
- D. Disk Group
Answer: C
NEW QUESTION 43
A systems administrator is performing a configuration change on a PowerMax array. Where does the configuration manager perform the change?
- A. SYMAPI
- B. MMCS
- C. Disk drives
- D. Host which performs the change
Answer: B
NEW QUESTION 44
Which command is used to change the CPU resource distribution for SRDF modes?
- A. symrdf
- B. symconfigure
- C. symqos
- D. symcfg
Answer: D
NEW QUESTION 45
Exhibit.
Which activity needs to be performed prior to the operations shown in the exhibit?
- A. Target volumes should be unmounted
- B. TTL setting should be changed
- C. Target volumes should be unmapped
- D. Snapshot should be terminated
Answer: B
NEW QUESTION 46
A PowerMax administrator modified a Storage Group to add more volumes. The administrator then decides to use the Suitability Check to ensure compliance is met. The Suitability check runs but does not provide any information.
What is the likely cause for this issue?
- A. Suitability Check was run before the Storage Group was configured
- B. Volumes were added to the Storage Group before using the Suitability report
- C. Steps were skipped in the Modify Storage Group setup before running the Suitability Check
- D. Array has not been registered for performance data collection
Answer: C
NEW QUESTION 47
On a PowerMax or VMAX Family array, what is the default Dynamic I/O distribution mode setting when a Storage Group is associated with Host I/O Limits?
- A. Balanced
- B. On Failure
- C. Always
- D. Never
Answer: D
NEW QUESTION 48
Which port flag is required for auto-provisioning?
- A. ACLX
- B. SC3
- C. V
- D. SPC2
Answer: A
NEW QUESTION 49
What is a recommendation when using Open Replicator to migrate data from a supported third-party array to a VMAX3 array?
- A. Host I/O to the control devices on the VMAX3 array is allowed after the migration completes
- B. Host I/O to the remote devices on the third-party array should be stopped for the duration of the migration
- C. Control devices on the VMAX3 array must be set to Not Ready for the duration of the migration
- D. Host I/O to the remote devices on the third-party array can continue during the migration
Answer: B
NEW QUESTION 50
When setting the TimeFinder SnapVX time-to-live with the symsnapvx command and the -delta 2 4 parameter, what does the delta parameter specify?
- A. Minutes
- B. Hours
- C. Days
- D. Weeks
Answer: C
NEW QUESTION 51
A systems administrator has decommissioned a host with two devices allocated to it. What must the administrator do prior to deleting the devices?
- A. Remove the device attribute
- B. Delete the Initiators
- C. Unmap from the front-end ports
- D. Remove the Storage Group
Answer: D
NEW QUESTION 52
Which SYMCLI command can be used to create a new TDEV and assign it to a Storage Group in one step?
- A. symdev
- B. symaccess
- C. symcfg
- D. symsg
Answer: B
NEW QUESTION 53
......
Dell EMC PowerMax and VMAX Family Solutions Specialist Exam Certification Details:
| Exam Code | DES-1121 |
| Exam Name | Dell EMC Certified Specialist - Implementation Engineer - PowerMax and VMAX Family Solutions (DCS-IE) |
| Duration | 90 mins |
| Exam Price | $230 (USD) |
| Books / Training | PowerMax and VMAX Family Configuration and Business Continuity Administration - Classroom (ES112STG00370) PowerMax and VMAX Family Configuration and Business Continuity Administration - Virtual Classroom (ES122STG00644) |
| Sample Questions | Dell EMC PowerMax and VMAX Family Solutions Specialist Sample Questions |
Dell EMC DES-1121 Exam Syllabus Topics:
| Topic | Details | Weights |
|---|---|---|
| Solutions Enabler Implementation | -Describe the functions of commonly used Solutions Enabler daemons, Solutions Enabler Virtual Appliance usage, and how Solutions Enabler is installed -Explain Gatekeeper management, option files usage, and environment variables | 7% |
| PowerMax and VMAX Family Configuration Administration | -Explain how PowerMax and VMAX Family arrays are configured and storage is provisioned -Describe virtual provisioning, service levels, and VMAX3 FAST concepts -Identify and describe PowerMax and VMAX Family device creation and port management -Explain how storage is allocated using autoprovisioning groups and how SL-based provisioning with Unisphere for PowerMax and SYMCLI isperformed -Identify and describe how Storage Resource Pools, Storage Group compliance, and Compression are monitored -Explain how Workload Planning with Unisphere for PowerMax is performed -Explain storage management in a virtualized environment for PowerMax and VMAX Family arrays | 41% |
| PowerMax and VMAX Family Local and Remote Replication | -Describe TimeFinder SnapVX architecture, features, capabilities, benefits,and management -Describe SRDF architecture, features, capabilities, benefits, andmanagement -Describe Open Replicator architecture, features, capabilities, benefits,and management | 9% |
Pass EMC DES-1121 Exam – Experts Are Here To Help You: https://www.pass4training.com/DES-1121-pass-exam-training.html
Get Latest DCS-IE DES-1121 Practice Test For Quick Preparation: https://drive.google.com/open?id=1aa2mOe4-QmkYZCZ7BYwtI5F5G090ZAa4
