Cisco 300-425 Exam Dumps [2022] Practice Valid Exam Dumps Question
300-425 Dumps - Grab Out For [NEW-2022] Cisco Exam
Cisco ENWLSD 300-425 Practice Test Questions, Cisco ENWLSD 300-425 Exam Practice Test Questions
Passing the Cisco 300-425 exam together with one more test, namely Cisco 350-401, is the only requirement for the CCNP Enterprise certificate. Those IT specialists who pick this professional-level certification track are trained to troubleshoot, install, and maintain both local area networks (LAN) and wide area networks (WAN) for systems somewhere within the range of between 100 and 500 hubs.
NEW QUESTION 28
A wireless engineer is designing a wireless network to support real-time applications over wireless. Which IEEE protocol mus the engineer enable on the WLC so that the number of packets that are exchanged between an access point and client are reduced and fast roaming occurs?
- A. 802.11i
- B. 802.11w
- C. 802.11r
- D. 802.11k
Answer: D
Explanation:
Explanation/Reference:
NEW QUESTION 29
Why is 802.11a connectivity reduced in an X-ray room?
- A. X -rays within these rooms cause multipath issues.
- B. X-ray rooms exhibit increased signal attenuation.
- C. X-rays impact the 802,11a UNll-2 channels that cause access points to dynamically change channels.
- D. X-rays create significant non-Wi-Fi interference on the 802.11a band.
Answer: D
NEW QUESTION 30
A wireless engineer is designing a wireless network to support real-time applications over wireless. Which IEEE protocol must the engineer enable on the WLC so that the number of packets that are exchanged between an access point and client are reduced and fast roaming occurs?
- A. 802.11i
- B. 802.11w
- C. 802.11r
- D. 802.11k
Answer: D
Explanation:
Section: Wired and Wireless Infrastructure
NEW QUESTION 31
An engineer is designing a wireless network that will support many different types of wireless clients. When conducting the survey, which client must be used to ensure a consistent experience for all of the wireless clients?
- A. the client with the worst RF characteristics
- B. the client that is used least by the company
- C. the client that is used most by the company
- D. the client that has the highest RF properties
Answer: A
Explanation:
Explanation
https://documentation.meraki.com/MR/WiFi_Basics_and_Best_Practices/Conducting_Site_Surveys_with_MR_A
NEW QUESTION 32
An engineer is designing a wireless network that will support many different types of wireless clients. When conducting the survey, which client must be used to ensure a consistent experience for all of the wireless clients?
- A. the client with the worst RF characteristics
- B. the client that is used least by the company
- C. the client that is used most by the company
- D. the client that has the highest RF properties
Answer: A
Explanation:
Explanation
https://documentation.meraki.com/MR/WiFi_Basics_and_Best_Practices/Conducting_Site_Surveys_with_MR_A
NEW QUESTION 33
Which statement about creating a mobility group is true, excluding mobility anchors?
- A. A mobility groups does not require all WLCs in the group to use the same virtual IP address.
- B. If WLCs with HA SSO are deployed, each WLC in the WLC HA pair considered separately as a mobility peer.
- C. Each WLC must use the same mobility name and be defined as a peer in each other's static mobility members list.
- D. The WLCs do not have to be of the same model or type to be a member of a mobility group, however each member should be running different software versions.
Answer: B
Explanation:
NEW QUESTION 34
Which UDP port numbers are used for exchange mobility packets in an AireOS wireless deployment?
- A. UDP 16666 for control plane, EoIP (IP protocol 97) for data plane
- B. UDP 16666 for control plane, UDP 16667 for data plane
- C. UDP 16667 for control plane, UDP 16666 for data plane
- D. UDP 16668 for control plane, UDP 16667 for data plane
Answer: B
Explanation:
NEW QUESTION 35
A network engineer is working on a design for a wireless network that must support data, voice, and location services. To support these services, which access point placement must the engineer use?
- A. perimeter only
- B. corner only
- C. indoor and outdoor
- D. perimeter and corner
Answer: A
NEW QUESTION 36
An engineer is designing an outdoor mesh network to cover several sports fields. The core of the network is located in a building at the entrance of a sports complex. Which type of antenna should be used with the RAP for backhaul connectivity?
- A. 2.4 GHz. 14-dBi omnidirectional antenna
- B. 5 GHz. 14-DBi patch antenna
- C. 5 GHz. 8-dBi omnidirectional antenna
- D. 2.4 GHz. 8-dBi patch antenna
Answer: C
Explanation:
Explanation
https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-antennas-accessories/product_data_she
NEW QUESTION 37
A wireless engineer is designing a wireless network for a warehouse using access points with internal antennas. Which two elements have a negative effect on the wireless users? (Choose two.)
- A. absorption
- B. client authentication
- C. wireless channels
- D. client authorization
- E. access point height
Answer: A,E
NEW QUESTION 38
A wireless engineer is designing a wireless network for a warehouse using access points with internal antennas. Which two elements have a negative effect on the wireless users? (Choose two.)
- A. absorption
- B. client authentication
- C. wireless channels
- D. client authorization
- E. access point height
Answer: A,E
Explanation:
Explanation
https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-1250-series/design_guide_c07-693245.html#
NEW QUESTION 39
What are the three RSTP port states? (Choose three.)
- A. Discarding
- B. Learning
- C. Initializing
- D. Blocking
- E. Listening
- F. Forwarding
Answer: A,B,F
Explanation:
Rapid Spanning Tree Protocol (RSTP) uses only three port states: discarding, learning, and forwarding. The learning and forwarding states are the same as the original STP standard, but the discarding state performs the functions originally performed in the disabled, blocking, and listening STP states.
With STP, you can safely assume that a listening port is either designated or root, and is on its way to the forwarding state. Unfortunately, once a port is in the forwarding state, there is no way to tell whether the port is root or designated. There is no difference in the operation of a port in blocking state and a port in listening state, since they both discard frames and do not learn MAC addresses. The real difference is in the role the spanning tree assigns to the port. RSTP decouples the role and the state of a port.
With RSTP, a role is assigned to a port. The root port and designated port roles are the same as with STP, while the blocking port role is split into the backup and alternative port roles. The Spanning Tree Algorithm (STA) determines the role of a port based on Bridge Protocol Data Units (BPDUs). The RSTP roles can be defined as follows:
Root port: The port receiving the best BPDU on a bridge (lowest-cost path to the root bridge) is the root port.
Designated port: The port that has the best path to the root bridge on a given segment is the designated port.
The bridges connected to a given segment listen to each other's BPDUs and agree on the bridge sending the best BPDU as the designated bridge for the segment. The corresponding port on that bridge is the designated port.
Alternative port: An alternative port is a port blocked by receiving more useful BPDUs from another bridge. It becomes the root port if the active port fails.
Backup port: A backup port is a port blocked by receiving more useful BPDUs originating from the same bridge. It becomes the designated port if the existing designated port fails.
Ports on the switch can also be classified as edge ports and non-edge ports. Access ports or edge ports are those that attach to devices such as workstations or printers. Non-edge ports are those that connect to other switches. If a non-edge port transitions to a forwarding state, a TC BPDU will be generated. On the other hand, when an edge ports transitions to the forwarding state, such as after a computer boots up or a device is connected to the port, no TC BPDU is generated.
Objective:
Layer 2 Technologies
Sub-Objective:
Configure and verify spanning tree
References:
Cisco > Support > Technology Support > LAN Switching > Spanning Tree Protocol > Technology Information > Technology White Paper > Understanding Rapid Spanning Tree Protocol (802.1w)
NEW QUESTION 40
A wireless engineer is designing a wireless network to support real-time applications over wireless. Which IEEE protocol mus the engineer enable on the WLC so that the number of packets that are exchanged between an access point and client are reduced and fast roaming occurs?
- A. 802.11i
- B. 802.11w
- C. 802.11r
- D. 802.11k
Answer: D
NEW QUESTION 41
A network engineer is preparing for an office site survey with a height of 2.5 meters. Which three components are recommended to complete the survey? (Choose three.)
- A. Use APs with built-in antennas.
- B. Use a drawing of the office space to draw AP and client placements.
- C. Use DoS attack on APs while measuring the throughput.
- D. Use APs with directional antennas.
- E. Use APs with external antennas.
- F. Use a battery pack to power APs
Answer: A,B,F
NEW QUESTION 42
A technician connects a Cisco Aironet 3700 Series access point to a switch and realizes that the AP is coming up with 3x3 MIMO. Which reason explains this behavior?
- A. A redundant power supply is unavailable on the switch.
- B. The AP is getting power from a power injector.
- C. The switch is 802.3af capable.
- D. The switch is PoE+ capable.
Answer: C
Explanation:

NEW QUESTION 43
When conducting a site survey for real-time traffic over wireless, which two design capabilities of smartphones and tablets must be considered? (Choose two.)
- A. fewer antennas than laptops
- B. no support for 802.11r
- C. higher data rates than laptops
- D. lower data rates than laptops
- E. no support for 802.11ac
Answer: A,D
Explanation:
NEW QUESTION 44
An engineer has deployed a group of APs in an auditorium and notices that the APs are showing high cochannel interference. Which profile can be used to adjust the parameters for these high-density APs?
- A. AVC profile
- B. QoS profile
- C. ISE profile
- D. RF profile
Answer: D
Explanation:
NEW QUESTION 45
A customer has two Cisco 550B WLCs that manage all the access points in their network and provide N+1 redundancy and load balancing. The primary Cisco WLC has 60 licenses and the secondary Cisco WLC has 40. The customer wants to convert the N+1 model to an HA model and provide SSO. Configuration must be performed during a maintenance window. After performing all the configurations on both controllers, the config redundancy unit secondary command is issued on the secondary Cisco WLC and it fails. Which parameter needs to be in place to complete the configuration?
- A. The secondary Cisco WLC needs a minimum of 50 base licenses
- B. The primary Cisco WLC is already set as the secondary unit.
- C. SSO needs to be enabled
- D. A cable in the RP port
Answer: A
NEW QUESTION 46
Which UDP port numbers are used for exchange mobility packets in an AireOS wireless deployment?
- A. UDP 16666 for control plane, EoIP (IP protocol 97) for data plane
- B. UDP 16666 for control plane, UDP 16667 for data plane
- C. UDP 16667 for control plane, UDP 16666 for data plane
- D. UDP 16668 for control plane, UDP 16667 for data plane
Answer: B
NEW QUESTION 47
......
WLAN High Availability
The questions from this section cover 20% of the entire content and are dedicated to evaluating the following abilities of the candidates:
- Design high availability for various controllers, including network availability through LAG, stateful switchover, as well as anchor controller priority & redundancy;
- Design high availability for APs, including fall-back (primary, secondary, and assigning tertiary) and AP prioritization.
300-425 Exam Dumps PDF Guaranteed Success with Accurate & Updated Questions: https://www.pass4training.com/300-425-pass-exam-training.html
Pass 300-425 Exam - Real Test Engine PDF with 113 Questions: https://drive.google.com/open?id=1zxMs8C6WxmkpAks334LhK-M9h1w0zBW6

